by Jeremy Viveros | Sep 15, 2026 | Blog Post
Here is something every new custom painter learns the moment they start spraying kandy over base colors: the same jar of kandy can give you a dozen completely different finishes. Spray it over silver and it lights up. Spray it over black and it goes dark and moody.... 
by Jeremy Viveros | Sep 3, 2026 | Blog Post
Every shop owner eventually runs the numbers on what it actually costs to spray one panel. The paint, the power, the air, the rework when a job comes back dull or contaminated. Most of the time the equipment sitting in the corner is quietly deciding those numbers... 
by Jeremy Viveros | Aug 27, 2026 | Uncategorized
You pull a fresh job out of the booth and the clear looks perfect. Deep, wet, glassy shine on every panel. Then a few hours later, or maybe the next morning, you walk back to it and the gloss has sunk. The surface looks duller, flatter, and cloudier than it did when... 
by Jeremy Viveros | Aug 12, 2026 | Uncategorized
You spend hours prepping a panel, mix your paint just right, lay down your coats, and then the surface dries with ugly bands of light and dark running across it. Those uneven stripes are called tiger striping, and they are one of the most common frustrations painters... 
by Jeremy Viveros | Jul 23, 2026 | Blog Post, Uncategorized
Why Hardener Choice Matters with Turbine HVLP You set up your turbine sprayer, mix your paint, and lay down a coat that looked perfect going on. An hour later you are staring at runs, slow cure, or a stubborn orange peel texture. If this sounds familiar, the...
Recent Comments